Gilbarco Advantage K35496, Introduction Manual

Assembling the Panels [M00781B001 (Encore Units Only)]

MDE-2636D Canopy Kits (K35496 and K35498) for The Advantage® Series and Canopy Kit (K96632-02) for Encore® · September 2012

Page 7

Assembling the Panels [M00781B001 (Encore Units Only)]

The Assembling Panels (M00781B001) are as shown in 

Figure 2

.

Figure 2: Assembling the Panels (M00781B001)

Hex Bolt 
(M01115B004)

Panels



(M00781B001)

Hex Nut 



(M01114B004)

Flat Washer (M00959B010)

Lock Washer (M01020B001)

Flat Washer (M00959B010)

To assemble the four major panels (M00781B001), proceed as follows:

Note: Before assembling, check the panel graphics for proper positioning.

1

Position the end panel and side panel, so that the two holes in each corner are aligned.

Note: Use the truck bed as a work table and assemble by placing either the short panel flat 

and installing the long panels from 

Figure 2

.

2

Place the Flat Washer (M00959B010) on the Hex Bolt (M01115B004), and then insert the 



Hex Bolt (M01115B004) as shown 

Figure 2

through one of the two pairs of aligned holes in 

both the panels.

Note: Use the needle nose pliers to hold the Hex Bolt (M01115B004) and Washer 

(M00959B010).

3

Fasten and secure the Hex Bolt (M001115B004) by installing in the following order:

• Flat Washer (M00959B010)
• Lock Washer (M01020B001)
• Hex Nut (M01114B004)

4

Repeat for each of the two holes on all the four corners of the assembly.