FlexPay NC3L Wide Installation and maintenance
33
8.2.3.
Insert new paper roll
1. Turn the new paper roll as shown in Figure 18. The paper should be inserted into the printer with the
temperature-sensitive side up.
2. Tear off a full turn of the paper from the new paper roll.
3. Make sure the printer is turned ON.
4. Cut the paper at a suitable angle (90°)
ATTENTION!
The paper sensor for 58 mm and 60 mm paper is at the same side as the interface
connector, while the sensor for 80 mm and 82.5 mm paper is on the power connector side. If
the paper is cut in a direction opposite to that as shown in the figure above, the sensor will not
detect the paper.
5. Insert the paper through the paper entry opening at the back of the printer.
The printer will now feed, cut and eject a printout, and then automatically go on-line.
