Operation
MetPak Base Station User Manual
Last Change
©
Gill Instruments Ltd
22 April, 2013
Page 43
The Reporting Page
with a
2 Axis
Wind Sensor connected can be used to select:-
Report Format
USERDEF
, FULL
or NMEA.
Select Parameters to Report
NODE,DIR,SPEED,PRESS,RH,TEMP,DEWPOINT,VOLT,STATUS.
NODE,U-AXIS,V-AXIS,PRESS,RH,TEMP,DEWPOINT,VOLT,STATUS.
Report parameters can be selected in any order or on or off in USERDEF.
The Reporting Page
with a
3 Axis
Wind Sensor connected can be used to select:-
Report Format
USERDEF
or FULL (NMEA not Applicable)
Select 3 axis Parameters to Report e.g.
NODE,DIR,SPEED,W-AXIS,PRESS,RH,TEMP,DEWPOINT,VOLT,STATUS.
NODE,U-AXIS,V-AXIS,W-AXIS,PRESS,RH,TEMP,DEWPOINT,VOLT,STATUS.
The PowerUp Page
can be used to select:-
Status Message Output
ON
or OFF.
E.g.
METPAK BASE STATION 2436 VB.44,
STARTUP: OK.
Report Message Output
ON
or OFF.
2 Axis
NODE,DIR,SPEED,PRESS,RH,TEMP,DEWPOINT,VOLT,STATUS,CHECK.
3 Axis
NODE,DIR,SPEED,W-AXIS,PRESS,RH,TEMP,DEWPOINT,VOLT,STATUS,CHECK.
Units Message Output
ON
or OFF
E.g. 2 Axis -
DEG,MS,HPA,%,C,C,V,-,-
3 Axis
DEG,MS,MS,HPA,%,C,C,V,-,-
NOTE:-
Once all settings have been chosen then save Edited Page Settings to MetPak Base
Station by clicking on ‘Save Settings to Device’ this will change the MetPak Base Station
configuration to reflect the new MetSet settings.
