GILMAN Gemini GHM30, Manual

4

OPERATION

Temperature settings

ClEANINg ANd CARE

Level: 0=Off (without light indicator)

1=Low heat (with light indicator)

2=Middle heat (with light indicator)

3=High heat (with light indicator)

•  Always disconnect the power plug from the socket outlet and let it cool down 

completely after use.

•  Remove the micro fleece cover from the heating pad was wash it. It can be 

washed by hand and machine (maximum at 30

˚

C)

•  Please ensure the micro fleece cover is completely dry before using with 

heating pad.

•  The PVC heating pad must not come into contact with water due to the risk of 

electric shock. Please wipe the heating pad with dry cloth.

IMPORTANT: 

SWITCH OFF THE HEATING PAD WHEN YOU DO NOT NEED HEATING. 

ALWAYS DISCONNECT THE POWER PLUG FROM THE SOCKET OUTLET WHEN 

YOU DO NOT USE IT. AVOID APPLYING PRESSURE ON THE SWITCH.

•  Firstly, put PVC heating pad into micro fleece cover.

•  Plug the power cable into the mains outlet.

•  Put the appliance on body properly (such as shoulder, back, arms, waist, neck, 

navel and knees)

•  Select from 1-3 temperature settings of switch control by scrolling to the 

desired setting.

•  It  takes  approximately  5  -  10  minutes  to  reach  the  desired  temperature. 

Remember that a temperature that the hand feels warm on may be extremely 

hot for the feet.

•  There is a odour when you first time to use the heating pad which is normal. 

This odour is completely harmless, but be sure to air the heating pad after it 

has been used for the first time.

•  Begin by heating the heating pad to the highest heat level. After 15 minutes the 

temperature can be adjusted to the desired level.

•  The heating pad’s heating function shuts off automatically after 90 minutes. If 

you wish to reheat the heating pad after 90 minutes, simply set the heat level 

back to 0 for approximately 5-10 minutes. You can then select the desired heat 

level once again. The heating pad is equipped with overheating control. 

•  Unplug the heating pad when it is not in use.

NOTE:

 DO NOT dip the controller or cable into water or liquid which will be 

damaged and excluded in the warranty.