4
CAUTION FOR STORAge
SPeCIFICATIONS
• Store electric over-blanket only when it is dry.
• DO NOT connect the over-blanket to power supply to dry it.
• DO NOT dry it in the sun or iron it, as this will cause safety problems because
of the aging of the insulating layer.
• When storing the electric over-blanket, allow it to cool down before folding.
Store the electric over-blanket in a clean and dry place. When storing, do not
place any objects on the electric over-blanket to prevent buckling.
• DO NOT use any mothproofing agent such as Naphthalene as this will damage
the insulation material.
eNSURe THAT
the power cord is not subjected to any excessive stress such
as: bending, bunching, twisting or pulling. The power cord should not be pressed
or trapped against any sharp objects whatsoever. Failure to do so may result in
an electrical short and pose a safety risk. The power cord should be allowed to
hang freely at all times. When storing over-blanket, loosely coil the power cord,
being sure not to crimp or pinch the cord.
Model no.:
GOB12
Product dimension:
160(L) x 120(W) cm (approximate)
voltage:
220-240v~ 50Hz
Output power (W):
120W
Switch levels:
0-1-2-3
Automatic switch-off Time : 180 minutes after switched on (approximate)
Please first check that the over-blanket is in good shape and is not damaged in
any way. In case of doubt, do not use the blanket and contact our service centre.
The following parts are included:
• 1 over-blanket with 1 controller with cable
• 1 Instruction manual
The packaging can be reused or recycled. Please dispose properly of any packaging
material no longer required.
WARNINg:
Please ensure that the polythene packing is kept away from the
reach of children! Risk of suffocation!
ITeMS SUPPlIed ANd PACkAgINg
• Clean the over-blanket by hand wash at maximum 30
˚
C. (recommended).
• You may also wash the over-blanket in a washing machine at a maximum
• temperature of 30ºC with low mechanical action and spin. It is recommended
• to wash it by hand in order to prolong the life of the product.
• To dry, lay the electric over-blanket flat on a moisture-absorbent towel or mat.
• When the electric over-blanket is completely dry, then reconnect the detachable
power controller. The electric over-blanket will only be operated with its provided
controller unit.
