GIMA D 500
cap_5 GIMA D500 GB
5.10
INK CARTRIDGE
If the use of the sealer is intensive, periodically verify :
-
there is not a ink surplus accumulation on the ink-ribbon visibile part
-
the ink-ribbon is not worn out (tear and/or fringe)
-
the ink-ribbon is correctly driven by the machine transmission
5.10 Replacement of the line fuses
Turning off the luminous green general switch (n.3-pict.1.1) and unplug it from the main supply (n.2-
pict.1.1)
-
open the fuse box drawer (n.1-pict.5.17) as shown
-
pull out the fuses to be replaced, eventually helping you with a suitable screw-driver
-
insert the new fuses and close the fuse box pushing the drawer
1
2
1
Line fuses
2
Fuse box drawer
pict.5.17
5.11
Replacement of the battery
When the display shows the relative message at the end of the BATTERY TEST, it is necessary to replace it.
The battery (MBB in the electric scheme cap.6 and pos.1-pict.5.18) is placed on the mainboard and must be replaced
when the sealer looses the memory of its data.
The keeping data battery has to be replaced with the machine switched off. This is important in order to
avoid any damages on the main board (pict. 5.18)
Do as follows:
-
open the upper cover and the front cover following as described in par.5.1
-
paying attention, push to the left the lever that allows to lock the battery and its contact: the battery will rise and may
be removed.
-
insert the new battery keeping the symbol “+” upwards
-
switch on the machine and wait for the positive result of the BATTERY TEST
-
Set current date and time (see par. 3.3.7)
