41
eLecTROMAGneTIc cOMPATIbILITY
InFORMATIOn
table 1
For all ME EQUiPMENt and ME SYStEMS
Guidance and manufacture’s declaration - electromagnetic emissions
The AD-2040 is intended for use in the electromagnetic environment
specified below. The customer or the user of the AD-2040 should assure
that it is used in such an environment.
table 2
For all ME EQUiPMENt and ME SYStEMS
Guidance and manufacturer’s declaration - electromagnetic immunity
The AD-2040 is intended for use in the electromagnetic environment
specified below. The customer or the user of the AD-2040 should assure
that it is used in such an environment.
Note:
U
T
is the a.c. mains voltage prior to application of the test level.
Emissions test
RF emissions
CISPR 11
RF emissions CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
compliance
Group 1
Class b
Not applicable
Not applicable
Electromagnetic environment - guidance
The AD-2040 uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
The AD-2040 is suitable for use in all
establishments other than domestic
and those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
iMMUNitY test
Electrostatic
discharge (ESD)
IEC 61000-4-2
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
iEc 60601test
level
± 6 kV contact
± 8 kV air
3 A/m
Electromagnetic environment -
guidance
Floors should be wood, concrete
or ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital environment.
compliance
level
± 6 kV con-
tact
± 8 kV air
3 A/m
ENGLISH
