12.
MEASUREMENTS
BOOM V2
CHECK
A kite must be set up as intended in order to perform.
To check a kite, all the lines should be measured in their total length. With the
help of a laser, each line can be measured with 5 kg of resistance with a tole-
rance of 5mm. It is very important for the kite to be symmetrical !
TRIM
The kite can only be trimmed with the length of the lines or with its speed system.
We recommend not to shorten the A’s or B’s, as the kite will not come faster, nor
go any further.
Pulling the B’s, the kite comes in a more stable way but goes less far in the window.
Pulling the brakes, the kite stalls less quickly, but when pulling too much, the
reflex of the profile already at the ready is taken away.
The distribution of the brakes on the trailing edge can influence downwind per-
formance and handling.
instructions
12.