ɸ
Nano 4 user manual
________________________________________________________________________________________________________________________________________________________
ɸ
Flying the Nano 4
Preparation for launch
Follow a consistent routine every time you fly. This is very important for safety. We
recommend the following procedure:
Material check
Check the following condition of your speedriding and other flying equipment before every
flight:
Ɣ
Is the glider fabric free from tears or other damage?
Ɣ
Are the lines free from knots, tangles or other damage?
Ɣ
Are the maillons connecting the lines and risers closed and secured?
Ɣ
Are your carabiners in good condition?
Ɣ
Are the risers in good condition?
Ɣ
Is your harness in good condition?
Ɣ
Are your trimmers in good condition?
Ɣ
Is your rescue correctly installed?
Ɣ
Is your rescue handle secure and rescue pin in?
Pre-flight check
A careful pre-flight check is required for any type of aircraft. Make sure that you exercise the
same level of care each time carry out the check.
Ɣ
Once you have arrived at the take-off, you should first take a look at the conditions:
observe wind speed and wind direction, airspace, turbulence and thermal cycles.
Ɣ
Check your speedriding glider, harness, rescue handle and pin, helmet and other
equipment.
Ɣ
Choose a wide starting place, as uniform as possible and free from obstacles.
Ɣ
Put on your harness and be sure to close the leg straps! Then put on your helmet.
Ɣ
Place the glider in a curved shape and sort the lines.
Ɣ
Connect the riser to the harness carabiners. Make sure that the carabiners are closed
and that nothing is twisted.
Ɣ
Check the correct position and symmetry of the trimmers.
Ɣ
Check one last time that there are no knots in the lines, nothing is twisted and that
the lines are not caught in vegetation, rocks or are tangled with your boots or skis.
You must be particularly attentive in lighter winds.
WARNING: If there are obvious creases in the glider as a result of tight packing or long
term storage, carry out some practice inflations before your first launch and smooth out
the trailing edge a little. This ensures that the flow profile is correct during launch. This is
particularly important in low temperatures.
ɸ
ɸ
ɸ
ɸ
Page 15
Summary of Contents for Nano 4
Page 1: ...Nano 4 User manual v1 0 December 2017...
Page 45: ...Dream Touch Believe...