Giordani pegasus plus isofix, Owner'S Manual

with the ISOFIX, please operate as fol-

lowing:

25. 

Extend the ISOFIX connectors and fix 

it into the ISOFIX anchorages until you 

hear an audible sound "click".

Fasten the car belt. Details please refer 

to the abovementioned instructions for 

the car belt installation for group 2/3.

CARE INSTRUCTIONS

Removing the 5-point harness system 

and cover

26. 

Open the snap buttons from the back 

of the car seat, then raise the cover as 

shown in the picture.

27. 

Push down the adjustment device and 

pull the harness strap out the strap 

yoke from other side to unlock it.

28. 

Pull the shoulder strap axle out, un-

tie the gap of the shell Then unite the 

shoulder strap and pull it out from the 

harness slot.

29. 

Loosen the bottom part of the cover 

and pull the belt clip through the belt 

clip slot. Then pull the buckle clip 

through the buckle clip slot.

30. 

Remove 5-point harness system then 

remove the headrest cover and the 

shell cover.

Refitting  the  5-point  harness  system 

and cover

31. 

After washing, place the cover on the 

shell.

32. 

Loosen the bottom part of the cover 

and pull the belt clip through the belt 

clip slot. Then pull the buckle clip 

through the buckle clip slot.

33. 

Put the end of the shoulder strap 

through the harness slot , fix into 

shoulder strap axle, and lock the 

shoulder strap axle to the seat shell .

34. 

Also put the end of the harness strap 

through the harness strap slot and 

shell, fix into the strap yoke, make sure 

the seat straps can not be rotated. 

35. 

Close the buckle, then fasten the cov-

er all around. Check that it works!

CLEANING

Please be sure to use only original seat 

covers, as the seat cover is important to 

the proper functioning of the system. Re-

placement seat covers are available from 

your retailer and or at branches.

The child seat must not be used without 

the seat cover.

The seat cover should not be replaced 

with any other than the one recommend-

ed  by  the  manufacturer,  because  the 

cover constitutes an integral part of the 

restraint performance. 

The 

cover can be removed and washed 

with a mild detergent using the washing 

machine's cycle for delicate items (30°C). 

Please observe the instructions on the 

washing label of the cover. The colours of 

the cover may fade if washed at more than 

30°C. Do not spin, and never tumble dry in 

an electric clothes dryer (the fabric may 

separate from the padding).

The 

plastic parts can be cleaned using 

soapy water. 

Do not use harsh cleaning 

agents (such as solvents).

The harness can be removed and washed 

in lukewarm soapy water.

Caution!

 Never remove the buckle tongues 

from the straps.

MATERIALS 

Cover:

100% Polyester

Frame:

 Polypropylene

SIZES

L: 69 cm;

H: 63 cm; 

D: 45 cm.

CHECKLIST

For safety’s sake read through this check-

list before you set off.

Check that the harness belt system fits 

properly and tightly around your child and 

that the shoulder belts are at the correct 

height.

Check regularly that the belt in the baby 

car seat is not damaged. If it is damaged do 

not use your product in any circumstances 

and contact your supplier or importer (see 

address list in the service card).

Check that you have secured your baby car 

seat with the seat belt.

If you have any questions, please contact 

your supplier.

• Make sure that you have the following 

details to hand:

• Serial number underneath on the service 

card.

• Mark and type of vehicle and seat on 

which the baby car seat used.

• Age and weight of your child.

WARNINGS

•  FAILURE TO OBSERVE THE AS-

SEMBLY INSTRUCTIONS PROVID-

ED BY THE MANUFACTURER MAY 

BE DANGEROUS FOR THE SAFETY 

OF THE CHILD.

• 

This is a child restraint system ap-

proved Regulation No.44,04 stand-

ards, for three different types of instal-

lation:

  - using the ISOFIX and Top Tether an-

choring systems, the device is clas-

sified as a "Universal" for Groupl(9-

18kg), which under more stringent 

26

27

conditions than those that were ap-

plied to earlier designs which do not 

carry this notice. 

  - using the child car seat without the 

optional ISOFIX, with the 3-point car 

seat belts, the device is classified as 

a "Universal" device, far Group 2&3 

(15-36kg).

  - using the optional ISOFIX, with the 

3-point car seat belts, the device is 

classified as a "Semi-Universal" de-

vice which is compatible for use on 

the vehicles indicated in relative "List 

of approved vehicles', for Group 2&3 

(15-36kg). 

• 

A correct fit is likely if the vehicle man-

ufacturer has declared in the vehicle 

the handbook that the vehicle is ca-

pable of accepting a "Universal" child 

restraint for this age group.

• 

To use the UNIVERSAL ISOFIX SYS-

TEM, it is approved to Regulation No. 

44, 04 series of amendments for gen-

eral use in vehicles fitted with ISOFIX 

anchorages systems. It will fit vehicles 

with positions approved as ISOFIX 

positions (as detailed in the vehicle 

handbook), depending on the catego-

ry of the child seat and of the fixture.

• 

The mass group and the ISOFIX size 

class for which this device is intended 

is: ISOFIX size class B1.

• 

If in doubt. consult either the child 

restraint manufacturer or the retailer.

• 

Read this instruction manual carefully.

• 

The correct fitting of the ISOFIX and 

Top Tether anchoring systems or 

3-point belt is of vital importance for 

the safety of your child.

• 

For the future use of the seat, it is im-

portant that you keep the instruction 

manual carefully.

• 

Never leave your child unattended in