Gira Control 19, Installation And Operating Instructions Manual

32

GB

For 230 V AC installation



Check whether the safety catch has been removed from the 230 V AC connection (17) 
and is attached to the 24 V DC connection (19).



If necessary, remove the safety catch from the 230 V AC connection and attach to the 
24 V DC connection.



Strip the mains voltage cable to the length of the included sheath.



Pull the included sheath over the stripped mains voltage wires.



Connect the 230 V AC mains connection cable to the connection terminal (3) in the 
flush-mounted box.



Connect the device connection cable to the connection terminal (3) and to the 230 V AC 
connection (17) of the Control 19.



Connect the network cable to the terminal (21) of the Control 19.



Mount the Control 19 in the flush-mounted box. Use the included screws for this.



Insert the design frame into the intended mounts and carefully pull down.

For 24 V DC installation



Check whether the safety catch has been removed from the 24 V DC connection (19) 
and is attached to the 230 V AC connection (17).



If necessary, remove the safety catch from the 24 V DC connection and attach to the 
230 V AC connection.



Connect the 24 V DC connection cable to the connection terminal (3) in the flush-
mounted box.



Connect the device connection cable to the connection terminal (3) and to the 24 V DC 
connection (19) of Control 19.



Connect the network cable to the terminal (21) of the Control 19.



Mount the Control 19 in the flush-mounted box. Use the included screws for this.



Insert the design frame into the intended mounts and carefully pull down.