Page 9 of 11
GC732G DC Motor Controller
Fig.4
To pair the 98GC229 Wall switch with a GC732G Motor controller follow the steps
below.
Note; When carrying out this part of the procedure each step must be
executed within 10 seconds of the previous one or the module will revert to
factory settings. It is highly recommended that you read and understand the
following sequence before attempting to execute it.
1)
Ensure that there is power supplied to the Motor controller.
2)
Press the Program button on the Motor controller. (The Red LED will start
blinking)
3)
Press the STOP button on the Motor Controller. ( The Red LED will remain ON)
4)
Press the IN button on the Wall switch. (The Red LED will extinguish)
5)
Press the OUT, STOP and IN buttons alternately on the wall switch to ensure
that the Modules have been successfully paired.
Program Button
