8
GC274A / GC274B AC motor Controllers
Fig.3
To pair the 98GC661B Wall Switch with a GC274A or GC274B first remove the lid of the
motor control module by pressing on the Lid release catches as shown in Fig.3
Note; When carrying out this part of the procedure each step must be executed
within 10 seconds of the previous one or the module will revert to factory settings.
It is highly recommended that you read and understand the following sequence
before attempting to execute it.
1)
Ensure that there is power supplied to the Motor controller.
2)
Press the Program button on the Motor controller. (The Green LED will start
blinking)
3)
Press the STOP button on the Motor Controller. ( The Green LED will remain ON)
4)
Select the desired channel on the wall switch.
5)
Press the IN button on the Wall switch. (The Green LED will extinguish)
6)
Press the OUT, STOP and IN buttons alternately on the wall switch to ensure
that the Modules have been successfully paired.
Lid Release
Lid Release
Program Button
