9
98GC74 AC Motor Controller
When pairing with the 98GC74 it is advised that the awning to be controlled is manually
extended couple of feet to enable the programmer to see if the awning is responding in
the correct direction when the buttons on the wall switch are pressed.
The programming window for this module is only 6 seconds so please ensure
that the programming instructions are read and understood before
attempting to execute them.
1)
Supply power to the motor control module. (It will beep ONCE )
2)
Press the P2 button on the wall switch TWICE. (The motor controller will beep
with each press)
3)
Select the desired channel on the wall switch.
4)
Press the IN button on the wall switch. (The awning should retract)
If the awning extends at this point instead of retracting, press the STOP button
immediately, then remove the power supply to the motor controller for at least 10
seconds.
Next repeat steps 1 and 2 above then press the OUT button on the wall switch to
complete the programming procedure.
Ensure that the awning responds correctly to the wall switch by pressing the OUT,
STOP and IN buttons alternately.
