GIRBAU SLI14, Installation And Operating Instructions Manual

28

Girbau, SA

113432-1

!

!

!

!

Preoperational Instructions __________

Important

For more detailed information regarding the
microprocessor controller (computer), refer to the

microprocessor user’s manual included with the dryer.

Coin Models

Microprocessor Controller (Computer)

When the microprocessor controller (computer) is in the ready
state, the L.C.D. screen will display “Ready, Insert $XX.XX
(amount) to Start”.

Insert coin(s).  Once the correct “Amount to Start” has been
inserted, the L.C.D. will display “Select Temperature”.

Select temperature by pressing “HI,” “MED,” or “LO.”  The
cycle will start and the L.C.D. will display the Dry Cycle selected
and the remaining time.

The dryer will continue through the drying and cooling cycles,
until the vended time has expired.

Note

To stop the dryer, open main door.  Continuation of
the cycle will resume only after the door has been

closed and any one of the 3 temperature selections is
pressed.

Non-Coin Models

Microprocessor Controller (Computer)

The L.E.D. display reads “READY” (no cycle in progress).

Press the letter on the keypad corresponding to the cycle
desired (e.g. key “D”).

The dryer will then start (i.e. blower, tumbler, and heat).

The L.E.D. display will read MANUAL DRYING CYCLE D,
___MIN REMAIN.

Note

The dryer can be stopped at any time by pressing
the “STOP/CLEAR” key, at this time the dryer will

go into a cycle pause.  If the “STOP/CLEAR” key is pressed
again at this point, the cycle that was in progress will be
cancelled and returned to the “READY” state.

When the programmed drying time has expired, the non-coin
microprocessor controller (computer) will proceed into the
Cool Down Cycle.

Once the Cool Down Cycle begins at the end of the heat
cycle, the L.E.D. display will read COOL DOWN TEMP ___/
___ MINUTES remaining.  At the end of the heat cycle, the
dryer will shut off the heat and continue the fan and tumbler
until the Cool Down Time or temperature is reached.

Shutdown Instructions ________________

If the dryer is to be shutdown (taken out of service) for a
period of time, the following must be performed:

Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.

Discontinue the heat supply:

Gas Models 

– Discontinue the gas supply.

Shut off external gas supply shutoff valve.

Shut off internal gas supply shutoff valve located in the gas
valve burner area.

Steam Models 

– Discontinue the steam supply.

Shut off external (location furnished) shutoff valves.

Service/Parts Information ____________

Service

Service must be performed by a qualified trained technician.
If service is required, contact the reseller from whom the
equipment was purchased.  If the reseller cannot be contacted
or is unknown, contact the Service Department for a reseller
in your area.

Note

When contacting the Service Department, be sure
to give them the correct model number and serial

number so that your inquiry is handled in an expeditious
manner.

Parts

Replacement parts should be purchased from the reseller
from whom the equipment was purchased.  If the reseller
cannot be contacted or is unknown, contact the Parts
Department for a reseller in your area.  Parts may also be
purchased directly from the factory by calling the Parts
Department at 3493 886 1100  or you may FAX in your order at
34 93 886 0785.

Note

When ordering replacement parts from the reseller
or the manufacturer, be sure to give them the

correct model number and serial number so that your parts
order can be processed in an expeditious manner.

!