33
EN
USER MANUAL
STI
12. ERROR CODES
Error Message
Description
Solution
----
Maximum load exceeded
Unload or reduce weight
Err 1
Incorrect date
Enter the date by using format “yy: mm: dd”
Err 2
Incorrect time
Enter the time by using format “hh: mm: ss”
Err 4
Zero setting error
Zero setting range exceeded due to switching on. (4%max)
Make sure platform empty(4%max) Make sure platform
empty.
Err 5
Key board error
Check the keys and connecter
Err 6
A/D value out of range
Make sure platform empty and check the pan is installed
proper. Check the load cell connectors.
Err 7
Percentage Error
Please check input data, must be > 0.5d
Err 8
Calibration weight error
Check the test weights for calibration or linear
calibration
Err 9
Unstable Reading
Check any air variation, vibration, RF noise and touching
some where. Check the load cell and connecters
Err 10
Wireless communication failure
Check wireless settings or change Com settings from the
wireless settings from the wireless
Err 11
Communication protocol error
Check communication settings
Err 12
Accumulation error
Max accumulation times 99 / 999 / weight 999999
Err 13
Lack of unit weight
Check unit weight entry data, must be >0.5d
Err 14
Lack of sample
Check counting samples entry, must be
>20d
Err 15
Gravity error
Check the gravity settings. Gravity range must be 0.9xx ~
Err 16
Paper error
Check the printer paper
Err 17
Tare out of range
Minus weight or overload. Remove the load and restart
Err 18
Pre-tare error
Check the pre-tare value
Err 19
Initialize zero error
Calibration the scale.
Err P
Printer error
Check the printer settings or connections
Err l
Approval setting error
Check the PCB jumper settings. Must be connect
jumper pin to K1 (BW series)
-- ol ---
Over range
Remove the load. Re calibrate
-- lo ---
Underload
Minus weight, check the platform and restart or calibrate.
fAil H
fAil l
fAil
Calibration Error
Check the test weights & Re calibrate
bA lo
lo bA
Battery low
Re charge battery, check the voltages.
Summary of Contents for Baxtran STI
