GIULIANO Crossage, Use And Maintenance Instruction Manual

13

                     The tyre changer may only and exclusively be used by expert, specifically trained and authori  

        sed personnel.

-  People with disabilities are not allowed to use the tyre changer as far as they cannot operate this safely due to their 

disabilities.

-  Tampering or modifications to the equipment that are not authorised in advance by the manufacturer relieve the latter 

from all forms of liability with regard to damages deriving from or referable to such actions.

-  Removal or tampering with the safety devices provides grounds to immediately annul the warranty and involves vio-

lation of European Safety Standards.

-  The tyre changer is equipped with informative and warning adhesive plates that are designed and produced to last 

in time. If they should deteriorate, the user may request replacement plates.

4.0_GENERAL INFORMATION

The tyre changer is designed to demount and mount tyres of cars and light vehicles with rims of 10” to 34” and maxi-

mum diameter of 1200 mm.

The tyre changer is designed to demount and mount conventional tyres of cars, light industrial vehicles, tyres of new 

generation type “self-supporting” RUN-FLAT and low profile tyres (UHP) with steel and/or alloy rim, even of conside-

rable dimensions.

The tyre changer is NOT suitable for demounting inflated or dirty tyres, to straighten rims or to remove wheel bead 

wires, consequently all these procedures are 

FORBIDDEN

.

.

5.0_GENERAL SAFETY INSTRUCTIONS

The tyre changer is to be used exclusively by qualified and authorised personnel.

A qualified operator is someone who has fully understood the instructions described in the use and maintenance manual 

supplied by the manufacturer, who has been specifically trained and who is aware of safety standards at the workplace.

Those in charge of using the machine shall not be under the influence of drugs, alcohol or other substances, which 

could compromise their physical and mental work abilities.

For greater safety, operators shall wear health & safety footwear, gloves, protection goggles and shall NOT wear any 

form of clothing that could get caught up or restrict the operator’s movements.

The operator must be able to:

-  

read and understand the danger warnings.

-  

understand the characteristics of the machine.

-  

keep unauthorised people away from the work area.

-  

make sure the machine is started in full observance of all the applicable safety standards and regulations.

-  

make sure all operators are familiar with the machine and how to use it safely and correctly.

- avoid touching live parts or pressurised parts without first disconnecting the machine from the electrical mains and pneumatic 

power supply.

-  

read and ensure full comprehension of the use and maintenance manual to be able to use the machine correctly and 

safely.

- keep the use and maintenance manual with care in an easily accessible place so that it can be consulted whenever need be.

IN THE CASE OF FIRE, USE EXCLUSIVELY POWDER EXTINGUISHERS OR ALTERNATIVE CO  EXTIN

-

GUISHERS TO PUT OUT FLAMES 

2