INSTALLATION
Ensure electricity is switched off at the mains before installing or maintaining this lantern.
THIS FITTING MUST BE INSTALLED IN ACCORDANCE WITH CURRENT IEE WIRING
REGULATIONS AND BUILDING REGULATIONS (PART P). FOR YOUR OWN SAFETY,
THIS LANTERN MUST BE EARTHED. UNDER NO CIRCUMSTANCES SHOULD
THIS METAL FITTING BE WIRED TO AN UNEARTHED CIRCUIT.
CONTACT A QUALIFIED ELECTRICIAN TO INSTALL A SUITABLE EARTH FACILITY.
IF YOU ARE IN ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
Please note: For new installations, check for any electrical cables or pipe work
(gas/water) in the vicinity of the intended mounting point for the product, before
proceeding with the installation.
1. Remove the back plate, by twisting anticlockwise. (FIGURE 1).
FIGURE 1
INSTALLATION
Ensure electricity is switched off at the mains before installing or maintaining this lantern.
This fitting conforms to UK safety standards.
THIS FITTING MUST BE INSTALLED IN ACCORDANCE WITH CURRENT IEE WIRING
REGULATIONS AND BUILDING REGULATIONS (PART P). FOR YOUR OWN SAFETY, THIS
LANTERN MUST BE EARTHED. UNDER NO CIRCUMSTANCES SHOULD THIS METAL FITTING
BE WIRED TO AN UNEARTHED CIRCUIT.
CONTACT A QUALIFIED ELECTRICIAN TO INSTALL A SUITABLE EARTH FACILITY.
IF YOU ARE IN ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.
PLEASE NOTE: For new installations, check for any electrical cables or pipe work (gas/water) in the
vicinity of the intended mounting point for the product, before proceeding with the installation
1. Remove the back plate, by twisting anticlockwise. (FIGURE 1).
