INSTALLATION - Continued
OPERATING THE LAMP
6. Push the lantern onto the back plate an 8th of a turn to the left.
7. Rotate the lantern to the upright position and use the plastic pin provided in the bottom of the
fitting to secure (Figure 1).
8. Turn on the mains supply.
9. Select function.
By flicking the mains switch on and off for the lantern and waiting for 10 seconds for the
lantern to boot up, you can select between 3 functions, indicated by the colour LED that can
be seen on the sensor.
Blue
P-LUX MODE – The lantern will work as a nightlight on dimmed mode from dusk until dawn
and brighten to its full output when motion is detected.
Green
PIR MODE – The lantern will come on at its full setting for 60 seconds after motion is detected.
It will then return to its off state.
Red
PHOTOCELL MODE – The lantern will be on full, from dusk until dawn before automatically
switching off at sunrise.
NOTE: Do not use this lantern if it is damaged.
Make sure that the lantern is fixed securely
IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.
NOTE: In the wiring examples shown in FIGURE 3, the switch for the fused spur doubles as the
override switch.
Initial Power Up Cycle
On the initial power up, your lantern will go into one complete cycle that is full light for 45 seconds
followed by a slow dim down and it will then switch off (in day time). This power up cycle will
happen regardless the light level of the environment.
After installing your P-Lux LED lantern, simply walk past your lantern and look for the coloured
LED (Motion Indicator) on the PIR to flash which means your lantern is in range but the light will
not come on in day light.
