Installation (continued)
13
Installing the shower head
□
Attach the shower head (C) to the shower arm
(B).
Hand-tighten only.
12
Checking for leaks
□
□
Turn the handle (F) to the full on mixed position.
When the valve body (D) is turned on, water
normally flows through the tub spout (J). To
activate the shower, turn the valve on and pull
the knob (1) up. Hold the knob (1) until the water
flows continuously from the shower arm (B).
Check for leaks.
Shut off the water at the faucet and supply lines.
□
14
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
UP
FOR
SHOWER
B
C
1
J
D
J
B
F
NOTE:
When the pattern of the water flow switches to
the shower from the tub spout, some low leakage from the
tub spout is a normal occurrence.
NOTE:
Do not use the thread sealant tape and do not use
wrench to tighten shower head.
