Page 6
GS-CHR-T5
1 and 2-way LED Remote Starter
Programming
Programming Options
Options in BOLD RED are default settings.
I G N
Turn Ignition On.
1
2
3
4
5
6
Press and hold valet
switch until antenna
LED flashes rapidly.
Press and release the
valet switch 1-37 times
for the desired channel.
Press and release
the brake pedal
once.
Press Lock(1), Unlock(2),
Trunk(3), or Start(4) on a
programmed remote to
select the mode.
1 2
3 4
O F F
Turn Ignition off.
The Channel will reset.
Functions
1
2
3
4
5
6
Add Remote
Ignition Configuration
Tachless Sensitivity
Run Time
Alarm Options
Door Lock Before And After
Remote Start
Mode 1
Button 1
Program Driver 1
Ignition
Increase Crank Time
Gas: 15 Minutes
Diesel: 30 Minutes
Sets Functions #7, #9,
#14 & #15 as default
Disabled
7
8
9
10
11
12
Safety Locks
Unlock Pulse Time
Active or Passive Alarm
& Starter Kill
Starter Kill Output
Mode 2
Button 2
Program Driver
Mode 3
Button 3
Multivehicle Programming
Accessory
+++++
Gas: 7 Minutes
Diesel: 14 Minutes
Enables Functions #7, #9,
#14 & #15 at mode 2
Start(Default)
++++(Default)
Gas: 3 Minutes
Diesel: 6 Minutes
Unlock before remote start
& Lock after remote start
Lock after remote start
Disabled
Unlock and relock after
shut down
Mode 4
Button 4
+++
Mode 5
Button 1 & 2
++
Relock 10 seconds after
shut down
Lock after foot brake & un
-
lock after key is turned off
Unlock after key is turned off
Single 0.25 sec.
Double 0.25 sec.
Single 4.0 sec.
Single 2.5 sec.
Single 1.5 sec.
Confirmation
Active -
Press Lock
to activate the Alarm
and Starter Kill
Passive(Lock Disabled)
Arm alarm & activate
starter kill 30 seconds
after door is closed
Passive(Lock Enabled)
Arm alarm, activate
starter kill & lock door
when the door is closed
Starter kill & Anti grind
Anti Grind only
Relay normally open
1st Lock/Unlock - Silent
2nd Lock/Unlock - Sound
----------------------------------
Antenna LED Active
Lock/Unlock
Sound Always
Antenna LED
Disabled
Antenna LED
Disabled with
ignition
13
14
Sound Confirmation
Confirmation Pulse
Horn Only
Long
Short
Alarm & Starter Options
Alarm disabled
Remote starter enabled
Alarm & Remote starter
enabled
Alarm enabled, Remote
starter disabled
Disabled
(Unlock Signal)
Automatically Lock and
rearm alarm if door(s) are
not opened after 30 seconds
15
Smart Door Lock
Relocking and Alarm
Rearming
Lock when starter kill arms
Arm pulse only when the
alarm is disarmed
16
Cold Start Timer
3 hours/Runtime
1.5 hours/Runtime
3 hours/5 Minutes
1.5 hours/5 minutes
Cold Time Off
17
Domelight Delay
Disabled
Enable-Ignore door trigger
(dome light) when arming or
Remote Starting
18
Diesel Mode
Disabled
Enable (20 seconds)
Delay between Ignition
power up and Starter crank
Enable (10 seconds)
Delay between Ignition
power up and Starter crank
19
Turbo Timer
Disabled
Run 2 minutes
Run 4 minutes
20
Engine Supervision:
-Tachless-
-Analog Tach-
-Tach Data-Link-
Tachless on crank and super
-
vision Tach Data-Link
or Analogic after.
Tachless Only
(automatic transmission only)
Start (crank) 8 sec on
tachless
(automatic transmission
only)
Start (Crank) 8 sec +
Supervision by Data-Link
Tach
(Data interface required)
Single 0.75 sec.
21
Start Attempts
2
Tach Data-Link only
(Data interface
required)
1
3
22
23
Transmitter Start/Stop
Function
Start(button 4) 1 sec.
Stop(AUX-button 4) 1 sec
Start(button 4) 3 sec.
Stop(AUX-button 4) 1 sec
Option alarm active
2-way remote Battery saver
Start(AUX-button 4) 1 sec.
Stop(button 4) 1 sec.
Master Reset
Rest All Options to
Default
Mode 6
Button 3 & 4
