3 of 4
Assemble the required amount of fixings
needed for the end panels by placing items
5,6 and 7 over item 4.
On the outside of the panel, peel back the
protective film around the perimeter of
the polycarbonate panel (Item 3) to reveal
the fixing holes. On the inside of the panel
remove the protective film entirely.
Lift the panel up against the frame and align
the holes with the fixing points in the frame.
Remove the remaining protective film from
the panel.
Insert the remaining fixings into each of
the holes and tighten using the allen key
to secure the panel. Repeat around the
perimeter, ensuring all fixings are secure*.
*NOTE: Take care, do not overtighten. If using a torque wrench or drill to tighten - a force of no more than 10Nm is required.
Insert the assembled fixings into the holes in
each corner of the panel and hand tighten to
temporarily secure it in place.
ASSEMBLY
Optional Polycarbonate End Panels
1
2
3
4
5
6
7
6
5
4
