4
Attach the Connector Rod (ITEM 10) to the Wheel Assembly Frame (ITEM 4) together
with the Frame Braces (ITEM 6 - 2off) using the M6 x 45mm Bolts (ITEM 24 - 2 off). The
fixings screw into an internal thread on the inside of the Connector Rod. Fix the Frame
Braces to the Hopper Frame (ITEM 7) using the M6 x 35 Bolts (ITEM 8 - 2 off) - Do not fully
tighten yet.
ITEM 24
E.
Fit the Inner Axle Bush (ITEM 11)
onto the right side of the Axle.
The Axle Bush (ITEM 5) should
be prefitted inside the Wheel
Assembly Frame (ITEM 4). Slide
the Inner Axle Bush until it slots
inside the Axle Bush in the
Frame.
Fit the remaining Inner Axle
Bush onto the left side of the
Axle. Again, slot the bushes
together snugly.
Fit the Wheels (ITEM 12 - 2 off)
onto the Axle. Begin with the
right hand Wheel and secure
in place using the M5 x 45mm
Bolt (ITEM 13) and M5 Lock Nut
(ITEM 14). Tap on the Axle End
Cap (ITEM 15) using a rubber
mallet. Repeat for the left
Wheel - inserting the 16mm
Flat Washer (ITEM 16) prior to
attaching the Axle End Cap.
ITEM 6
ITEM 8
ITEM 10
D.
ITEM 5
ITEM 11
ITEM 13
ITEM 15
ITEM 15
ITEM 16
ITEM 14
ITEM 12
ITEM 7
ITEM 4
