5
F.
The Upper Handle (ITEM 19 - 2 off) can
be fitted in three positions along the
Handle Shaft (ITEM 17).
Select the most comfortable position
for use. Should either of the two higher
positions be chosen, fit the Handle
Spacer (ITEM 20) in the top fixing hole
of the Upper Handles with an M6 x
45mm Bolt (ITEM 24), 6mm Flat Washer
(ITEM 21) and M6 Lock Nut (ITEM 9).
Take the Gauge and Lever Assembly
(ITEM 22) and align the holes with
the holes in the Upper Handles and
Handle Shaft.
Ensure the Gauge and Lever
Assembly is on the right hand side and
the Handle Lever is facing forward.
Secure in position using M6 x 45mm
Bolt (2 off), 6mm Flat Washer (2 off)
and M6 Lock Nut (2 off) (ITEMS 24, 21
and 9).
ITEM 17
G.
Insert the Handle Shaft (ITEM 17) between
the two Wheel Assembly Frames (ITEM 4)
ensuring the Handle Shaft is in the correct
orientation. The lower holes are further
from the end of the Handle Shaft.
Take the Pivot Bracket Assembly (ITEM
18) and align with the holes in the Wheel
Assembly Frames and Handle Shaft.
Secure in position using M6 x 45mm Bolt
(ITEM 24 - 2 off) and M6 Lock Nut (ITEM 9 -
2 off).
FULLY TIGHTEN ALL NUTS AND BOLTS
WITHIN THE ASSEMBLY FROM STEP A
- DO NOT OVER TIGHTEN -
ITEM 24
ITEM 18
ITEM 9
ITEM 24
ITEM 22
ITEM 20
ITEM 19
ITEM 18
ITEM 9
ITEM 21
ITEM 4
