15
16
Outside
ll
at
S
re
w
o
hS
/
b
uT
Sketch 16A
View looking from inside
Tub/Shower Enclosure
Center Guide # 14
Screws # 8
Readjusting Rollers on the Glass Hanger.
NOTE: this step is only performed if necessary.
Remove Glass Panels from Header with same movement repeated backwards.
Please note there are a set of pre-drilled holes on hanger,
Sketch 15B.
Using screwdriver, loosen and remove the screws that fasten rollers and hanger.
Move the rollers up or down to desired location. Fasten the screws back.
Make sure that screw is tight and roller
will not come off the hanger during the use.
Sketch 15B
Installing Bottom Guide.
Stand inside the Tub/Shower Enclosure and slide both glass
panels to one side of the enclosure.
Install the center guide by sliding it to the center of the base.
Carefully drill 1/32” holes and insert screws as shown in
SKETCH 16A
There should be 1/4-5/8 space between bottom edge of the glass and Base (Sketch 10A).
That space is necessary for Center Guide.
If it is less or more than mentioned limits the rollers must be moved up/down.
Outside
1/4”-5/8”
