Glasswelt GARLAND CHOPPER 607 VE Instruction Manual Download

Page: 41 / 120

English

41/120

left hand controls the left lever while the right hand
controls the right lever.

5. To stop the blade, release any of the levers and the
blade will go backward to the start position.

5.3.4. CHECKPOINTS AFTER COMMISSIONING

It is important to pay attention to the possible loose
parts or the temperature of the machine. If you
detect any anomaly in the machine immediately stop
and check it carefully. In case of any malfunction or
problem take the machine for service for repaired.
Under no condition should you continue to use the
machine if the operation does not seem appropriate.

5.3.4.1. VERIFICATION OF THE SECURITY SYSTEM

Check that the safety system works correctly by a
testing of the machine without a trunk. To do this,
switch on the engine by pressing the switch and
pushing both the hydraulic control levers at the same
time, the blade will begin its cutting motion. While the
blade is moving stop pressing the left lever and blade
should stop and move back to its original position.
Then perform the same test operation.

If after the test you detect that the machine does
not function as described in this point do not reuse
the machine until it has been reviewed by a service
technician.

5.3.4.2. LEAK VERIFICATION

Check that there are no oil leaks in the machine. If you
detect a leak, take your machine in for service.

5.4. AFTER USE

Once you have stopped using the machine:
1. Disconnect the power source of the machine by
pressing the switch in position “O”.

2.  Unplug the machine.
3.  When you stop using the machine tighten the
  bleed screw to prevent oil leakage from the

bandsaw through the trap.

6. USING THE MACHINE

Use this machine only for the designated

purposes. Using this chainsaw for any other use is
dangerous and can cause bodily harm and/or damage
to the machine.

Never force the bandsaw for more than 5 seconds
by pressing on a trunk too hard. After this interval,
oil that is under pressure can overheat and damage
the machine. For logs of extreme hardness, turn the
log 90 degrees to try to cut it in another position. If
still cannot cut the trunk, it means that this exceeds
permissible hardness so trunk should be discarded
and thus prevent damage to the machine.

Note: Is strictly forbidden to use the bandsaw by two
people with a clamping trunk and the other pressing
the levers. Locking a lever (to only having to operate
with lever) is also prohibited.

6.1. LOG CUTTING

1.  Adjust the work table to the proper height
  according to the trunk you are going to cut.
2.  Follow the steps in point 5.3. “Start-up”.
3.  Place the trunk on the work table and grasp it
  firmly between the clamps. Make sure the trunk
  does not become kinked, move or slip while they
  are being cut.
4.  Simultaneously press both the hydraulic control
  levers down.
5.  Break the trunk.
6.  Stop pressing the levers so that the blade is

removed.
7. Once work is complete, follow the steps in point 5.4.