GLD Products
Vtooth 1000EX Dartboard
Item 42-1037
1-800-225-7593
www.gldproducts.com
5
IMPORTANT: This electronic dartboard operates using the GLD Live Dart Scorer application. The
application must be installed on a compatible device that uses Bluetooth
®
communication.
TOOLS REQUIRED
•
Tape Measure
•
Nail or Marker
•
Phillips Screwdriver
•
Level
•
Mounting Hardware (provided)
•
2 AA Batteries (not included)
UNPACKING THE DARTBOARD
After unpacking the game, it is important to save the original box, all packing material, and the receipt.
These items will be needed if it ever proves necessary to return the game for service.
MOUNTING (PHYSICAL INSTALLATION)
Two methods for mounting the dartboard are available.
1.
Use the two keyhole slots and mount the center of the dartboard following the illustration. The two
screws are screwed into the wall until the screw head is 3/8" away from the wall. The dartboard is
positioned so the two screw heads are inside the keyholes. Slide the dartboard down to secure.
The head of the screw that is used must be larger than 1/4" and smaller than 3/8".
2.
Four equally spaced holes are accessible from the front to drive in screws. With the dartboard held
in place, four screws are driven in from the front, through the existing holes. Use 1/8" diameter
screws. The head of the screw must ! t inside the pocket.
Wall Anchors
1.
Locate a stud and use wood screws or sheet metal type screws to secure the mounting bracket.
2.
If a stud cannot be located or is not in the proper location, use the plastic anchors and screws.
Some common anchors are:
Plastic
- Drill a snug hole in drywall and push the anchor in up to
the head. When the screw is screwed into the anchor, the plastic will
expand, locking the anchor in place. Do not use on thin paneling.
Toggle Bolt
- Drill hole through wall. Hole must be large enough for the
wings to pass through. Insert screw through the holes in the mounting
bracket and thread the toggle wings just onto the screw. Fold the wings
back and push through the hole until the wings spring open. Pull back on
the screw to hold wings against the inside of the wall and tighten screw.
Hollow wall anchor
- Drill a snug hole through the wall. Tap anchor
into the hole until the prongs on the underside of the head are seated
securely into the wall. Turn screw in and apply pressure to keep the
anchor head from turning. Tighten screw until resistance is felt. Do not
over tighten. Turn screw out to remove. Anchor will stay and screw can
be replaced.
Other methods are available. Consult a hardware store if questions arise.
