GLD Products
X-treme Dartboard
Item 42-1022
1-800-225-7593
8
www.gldproducts.com
POWER INSTALLATION
The dartboard is designed to be powered by an AC to 5V DC, 500 milliamp (minimum)
adapter, with the DC plug polarity configured as positive (+) outside, and negative (-) center.
To connect the adapter, plug the DC plug into the DC power jack on the dartboard and the
AC plug into an electrical outlet.
1. The board is not intended for children under the age of 12 years old.
2. The board must only be used with the recommended transformer.
3. The transformer is not a toy.
4. Disconnect the dartboard from the transformer before cleaning.
PROTECTIVE FILM
This electronic dartboard has a clear protective film over the entire display and button area
to prevent scratching during shipping. It is recommended that you remove this film for easier
reading of the display. To remove, simply lift edge, peel off and discard.
WARNING:
Not for use by children without adult supervision.
Darts are not toys and may cause injury if used
improperly. Everyone must stand behind the dart
thrower.
IMPORTANT NOTES
1. During shipping or in the course of normal play, it is possible for scoring segments of this
board to become temporarily jammed, resulting in a “frozen” board. If this occurs, the
built-in
Self Diagnostic Function
of the e-BOARD Computer will be activated
automatically. Your dartboard will run a self-test routine to determine which segment is
stuck. An error message will flash on the display together with the number for the
“Frozen” segment.
Error Code
Malfunction
99
Stuck ENTER Button
98
Stuck ELIMINATE Button
97
Stuck BOUNCE Button
96
Stuck ON/OFF Button
95
Stuck DOWN Button
94
Stuck UP Button
93
Stuck FAVORITE Button
92
Stuck AUTO CHANGE Button
91
Stuck SOUND Button
90
Stuck START/NEXT Button
Segment Number
A segment is stuck