INSTALLING AND CHANGING THE CARBON FILTER – PART NO. CF260
This rangehood can be fitted with an optional carbon filter that will aid in the removal of grease,
smoke and cooking odours from the air before it is recirculated into the room.
The square carbon filter attaches to the base of the motor housing above the aluminum mesh
filters. Detailed instructions for fitting and replacing the carbon filter can be found below.
We recommend replacing the carbon filter every 3-4 months or sooner, depending on how
frequently the rangehood is used, otherwise the performance of the rangehood can be impeded.
1. If the rangehood has a perimeter panel,
then pull down to reveal the mesh filters,
otherwise proceed directly to Step 2.
2. Push the handle of the aluminum mesh
filters towards the rear of the rangehood
until they’re released from the housing
and then remove them and set aside.
3. If replacing a carbon filter, release the
old one from the housing and pull down.
4. Insert the new carbon filter and snap into
the housing.
5. Re-insert aluminum mesh filters (set aside
in step 2) into the housing ensuring they
click into place.
6. Close the perimeter panel (if applicable)
3
4
2
1
10
Summary of Contents for AAG6SE1
Page 15: ...Installation 15...
