CHAPTER FOUR: SETUP AND TUNING
Note
: There is no setup or tuning required by the end user. All the setup and tuning are pre-
set at the factory. Should the customer must make any major change (such as using
different motor and/or feedback), please contact one of Glentek’s sale engineers for
help in setup and tuning the amplifier for optimum performance. If minor change (such
as adjusting input command offsets, etc.) to the amplifier, use the procedures as follow
for reference.
4.1. Turning the Power On.
Carefully recheck the wiring. Restore power to the VMC. After the VMC is finished
initializing, check the vector drive status 7 segment display. One segment may be
lighted or if the spindle is rotating slowly you will see a rotating pattern of segments
lighting.
4.2. Establishing Communications
Connect your laptop to the vector drive at P3.
Open MotionMaestro 1.37 or later version and go to the communication menu drop
down and select
OPEN
.
The
Open Communications
dialog box will appear.
Press the OK button and the COM status box to the right will turn green.
10
Summary of Contents for SMB9675-1A-1
