3” DIAMETER STORAGE KITS:
(If you purchased a 4” diameter storage kit, go to 4” diameter storage kit instructions below.)
a. Attach tube assembly to base unit.
b. The resin insert adaptor must be inserted into the end of the tube. (Image 11)
c. Insert Crank handle through the base unit and into the resin insert adaptor. (Image 12) Be sure to align the
axle hole.
d. Fasten tube to base unit using the 2.83” axle bolt that is packaged with your base kit. (Image 13)
e. Repeat same procedure on opposite end.
4” DIAMETER STORAGE KITS:
Note: The 4” storage kit is packaged with two metal insert adaptors and two resin insert adaptors. See pictures
of each. (Image 14) You will use the large resin insert adaptors for your installation.
a. The small resin insert adaptors that were packaged with the base kit and the large metal insert adaptors that
were packaged with the storage kit can now be discarded as they will not be used.
These can be seen in
Image 14, and are noted to be discarded.
b. The resin insert adaptor must be inserted into the end of the tube. (Image 15)
c. Insert Crank handle through the base unit and into the resin insert adaptor. Be sure to align axle hole. (Image
16)
d. Fasten tube to base unit using the 3.75” axle bolt that is packaged with your storage kit. (Image 17) Note:
the 2.83” axle bolt that is packaged with your base kit can be discarded as it will not be used.
e. Repeat same procedure on opposite end.
Image 11
Image 12
Image 13
Image 14
Image 15
Image 16
Image 17
Youngstown, Ohio 44510 • www.glipoolproducts.com
8.
Attach Straps to Tubes:
Come in 6 inches from each tube end and attach a strap plate to the tube assembly. Use the self drilling screws on the drill line to attach the
plate. Look at the holes that were pre-drilled at the factory and use the same drill line. There are 6 lines on each tube. Take the remaining strap
plates and connect them evenly along the length of the tube assembly. Attach straps to strap plate. (Fig. D)
9.
Attach Solar Blanket to Straps:
If reel is to be placed at the end of the pool, attach cover to strap plate with plastic screw. (Fig. E) If reel is to be placed in offset position, then
attach cover to strap plate forming a fold to act like a hinge and the plastic screw will go through two layers of the solar blanket. (Fig. F)
Bubbles should face down.
Twist
Tubing To
Remove Excess
Play Prior
To Screwing
Together.
Fig. C
Thread
Strap
as Shown
Fig. D
Solar Blanket
Strap & Bracket
Plastic Screw
Fig. E
Fig. F
Solar Blanket Folded
Plastic Screw
Strap & Bracket
DISCARD
