PV Glider Manual v. 2 rev B www.glidebikes.com
2 of 11
Figure 1
Your glider comes partially assembled. The only things that you need to do is to install the
front wheel , install and adjust the handlebar, and set the seat height.
Installing Front Wheel.
1.
Glider should be turned so that fork is facing upwards and seat is down inside box.
2.
Loosen nuts on front wheel with fingers so that nut is still attached to axle, leaving ¼ to
5/16” of the threaded axle exposed.
3.
Slide wheel on to fork, so that washers and nuts are positioned on outside of fork leg.
4.
Safety tab should be locked into safety locking hole.
