34
The wheel is now ready to be replaced back on the wheelchair. Before inserting on
gearbox shaft, clean shaft with a cloth and slightly grease the shaft. Insert 5mm Key
onto gearbox shaft and line hub keyway up with shaft key and slide wheel back on. Re-
install the retainer washer and Nyloc Nut to shaft and tighten nut to 50 nm torque. It is
recommend a new nut be used each time.
⚠
Warning
Once installation is complete, test drive wheelchair by
Stopping/ Starting and turning several times to ensure it drives correctly.
Summary of Contents for CentroGlide
Page 37: ...37 ...
Page 39: ...39 ...
Page 50: ...50 Dahl CentroGlide adaption kit 502237 ...
Page 64: ...64 ...