SWING GATE OPENER - SW 300
INSTALLATION- Auto Gate
OPERATION
SETTINGS- Auto Gate
STOP Motor
immediately
.
Ensure that the gate moves
in full extent. Weld the tip
clamp strong.
Install the other motor.
.
Mount Base Bracket with Anchor
Bolt & Lead Plate, corresponds to a
horizontal section of gate, as per the
measurements
Close the gate. Release Motor Gear.
Take water level from this Lead plate to
the gate and mark.. Screw the Motor
Arm to the LEAD Plate. Extend the
Motor Arm fully out. Rotate Arm
Extension ONE Turn clockwise. Spot
weld the Tip Clamp to the gate.
Connect both motors
electrically, to the
control board.
Ensure that the Pillar is strong
enough to mount the Motor Bracket.
Reverse that
Motor
connections
, in the
control Board
Both Gate
Opens.
Any Gate
Closes
START - 2S
Keep the gate half
way open & engage
gear.
Do appropriate
Preset settings.
eeeEnsure
ff4fssssssettingsset
tings.Switch 8
Do
Electrical
Connections
Ensure that both
gates start and run
in full speed and go
to slow speed just
before stopping.
