17
.
6.
As the motor begins to slowly propel the scooter forward, place the foot which pushed
off the ground onto the riding board behind your front foot. Press the thumb control
more to increase speed when feeling comfortable and safe.
Stop
:
1.
Squeeze the hand brake to begin the braking process. The harder and faster you
squeeze, the quicker the stopping process. The brake is located in the rear wheel. In a
safe, controlled environment, please familiarize yourself with the braking distance of
the scooter at various speeds before operating near intersections, pedestrians and other
obstacles.
1.
put your feet on the ground at any time in case of emergency. Never raise the seat
height with Safety Line of the upper seat post above the quick release on the lower seat
post.
2.
Raise the kickstand.
3.
Set the speed mode to S.
4.
Adjust the rear view mirror so that you can see traffic from behind.
5.
With both hands on the handlebars and one foot on the standing board and one foot on
the ground, slowly press the accelerator.
6.
As the motor begins to slowly propel the scooter forward, place the foot on the ground
onto the riding board. Press the thumb control more to increase speed when feeling
comfortable and safe.
WARNING: Always ride at speeds you can comfortably and safely
control. Take the time to familiarize yourself with the brakes and the
distance it takes to come to a complete stop at various speeds. Keep both
hands on the handle grips while operating the scooter at all times. Never
take your eyes off the road. Failure to do so could result in serious injury or
death.
Each electric scooter is equipped with a lithium battery and a smart charger designed specifically
for each other.
Do not charge the battery with any other charging system. If the battery or
charger is damaged due to improper use, the limited manufacturer warranty shall be void. Do not
operate the charger near flammable materials such as carpet. Ensure a dry environment. Never
allow the charger or cable to come into contact with water as this may result in electric shock.
Never touch the charger or cable with wet hands. Disconnect the charger from the outlet if any
fault arises during charging. Always pull the plug, not the cable. Do not allow the charger or
cables to be damaged or crushed by sharp edges or heat. The charger supplied with the electric
scooter should be regularly examined for damage to the cord, plug, enclosure and other parts. In
the event of such damage, the scooter must not be charged until the charger has been repaired or
replaced. Unplug the charger and disconnect from the scooter when not in use.
