System Installation
3-3 M-systems Flash Disk
3307114 reserves one 32-pin DIP sockets for installing M-systems Flash disk
from 2MB to 288MB. This operation structure is running with pure ISA-bus
without PnP (Plug and Play) function. Before installing, make sure that I/O
address jumper setting is set on right position to prevent unworkable system
due to I/O resource conflict. Do remember to follow DOC (DiskOnChip)
installation procedure. Otherwise, it is possible to burn out the Flash chip due to
incorrect installation.
Installing DOC
Align the DOC with pin holes on the socket. Make sure that the notched corner
or dot mark (pin 1) of DOC corresponds to notched corner of the socket. Then
press the DOC gently until it fits into place. If installation procedure is correct,
the Flash disk can be viewed as a normal hard disk to access read/write data.
WARNING
Please ensure that your DOC is properly inserted. Placing the DOC in
reverse will cause severe damage. Remember, a new DOC chip is always
a formatted disk. You may simply plug the chip on the DOC socket and
read/write through it. If you would like to boot from this Flash disk, it is
necessary to refer to the application note from M-systems. You can easily
get relative information from M-systems shipping package (such as
product manual) or Web-site
http:/www.m-sys.com
.
3307114 User’s Manual
3-
3