STEP# 2 – HANDLEBAR ASSEMBLY
WARNING: For safe operation, the clamp bolts must be securely tightened.
NOTE: your handlebar has been pre-assembled to the stem at our factory. For 4-7 please use this information for
adjustment and future reference.
1. Insert stem into head tube and tighten the bolts by M6 Allen Key (Recommended torque is 35-45 Newton
Metres),
especially pay attention to the insertion warning mark.
2. Check steering by straddling the front wheel and trying to turn the handlebar. If you can turn the handlebar
without turning the front wheel, the stem is too loose. Adjust the handlebar angle which is perpendicular to
front wheel. Retighten the stem pillar bolt.
3. Lift up the quick release of stem(A) in order to close the top stem(B), then lock the clamp(C).
4. Loose clamp on stem.
5. Adjust handlebar to desired angle.
6. Securely tighten clamp. (Recommended torque is 8-12 Newton Metres)
7. Check handlebar for tightness. If you can move it forward or backward, the clamp are not tight enough.
WARNING: HANDLEBAR GRIPS OR TUBE END PLUGS SHOULD BE REPLACED IF DAMAGED, AS
BARE TUBE ENDS HAVE BEEN KNOWN TO CAUSE INJURY.
①
②
③
B
A
C
Summary of Contents for EVOLT
Page 2: ...PARTS LIST M15 SPANNER M6 ALLEN KEY CHARGER...
Page 11: ...A B A C B D FOLD THE EBIKE...
Page 18: ......
