7
Combination Sander
12. Attach Disc Cover using sheet metal screws.
13. Insert Support Bar (4) through through-hole A shown
in figure to the left. Secure using M8 x 20mm set
screw.
14. Slide Table Assembly (2) onto Support Bar (4) and
secure using M8 x 10mm set screw.
15. Using a square, ensure that the table is perpendicular
to the disc sander. Secure the table in this position.
16. To use table assembly with belt sander, repeat steps
13 through 15 using through-hole B shown in figure
to the left.
Disc Cover
Through-Hole A
Through-
Hole B
M8 Set Screw
M8 Set Screw
Belt Sander Table Configuration
17. Attach Dust Exhaust (9) using a M6 x 10mm pan
head screw.
M6 Screw
Sheet
Metal
Screw
