Page | 6
SUPERIOR SERIES POOL LIFT OPERATING INSTRUCTIONS
Prior to using the Superior/Proformance Series Pool Lift perform a test run of the lift
empty. Once that is completed and the lift is back to original position, make sure that
the arm lifts are in the up position and the seatbelt is unbuckled, once acknowledged
you are ready!
Once you are in the seat, buckle the seatbelt (make sure it is snug) and lower the arm
rails. Before you attempt to operate the lift, make sure the pathway is clear from any
obstacles.
Once you have the 2 button easy controls in your hand, press the arrow that specifies
down, keep in mind you don’t have to go to the bottom of the cycle, you can stop the
lift whenever you deem comfortable to exit the lift. However when exiting the pool
while on the lift, you should complete the cycle back to the top to have a completely
safe exit from the pool.
Once submerged into the pool, unbuckle the seatbelt and raise the armrest and slide off
of the seat. Once you are done with your pool activity, make sure the seat is lowered
sufficiently to allow you too easily slide back into the chair. Once you are seated, buckle
the seatbelt and make sure that it is snug, lower the armrest.
Next, to raise the lift chair out of the pool, make sure you press the button/arrow that
represents up on the control. Apply continuous pressure until the lift comes to a
complete stop at the end of the complete up cycle on the deck. You now can unbuckle
the seatbelt and raise the arm rest and exit the unit. Staff will turn the key on the hand
control or front of the control panel to re-lock the lift when the pool is not in operation.
In the unlikely event that the lift does not return from the water using the hand control,
have an attendant press the emergency return button on the front of the control box or
on the underside of the control box and the lift will return to pool side.
