Global Machinery Company MRHD1500, Manual

GB

5

c. Disconnect the plug from the power source and/or the 

battery pack from the power tool before making any 
adjustments, changing accessories, or storing power 
tools.

 Such preventive safety measures reduce the risk of 

starting the power tool accidentally.

d. Store idle power tools out of the reach of children and do 

not allow persons unfamiliar with the power tool or these 
instructions to operate the power tool.

 Power tools are 

dangerous in the hands of untrained users.

e. Maintain power tools. Check for misalignment or binding 

of moving parts, breakage of parts and any other 
condition that may affect the power tool's operation.

If 

damaged, have the power tool repaired before use.

 Many 

accidents are caused by poorly maintained power tools.

f.  Keep cutting tools sharp and clean.

 Properly maintained 

cutting tools with sharp cutting edges are  
less likely to bind and are easier to control.

g. Use the power tool, accessories and tool bits etc. in 

accordance with these instructions, taking into account 
the working conditions and the work to be performed. 

Use of the power tool for operations different from those 
intended could result in a hazardous situation.

5. SERVICE
a. Have your power tool se rviced by a qualified repair 

person using only identical replacement parts.

This will ensure that the safety of the power tool is maintained. 

Additional Safety for Hammer Drills

• For safety relating to protective clothing/equipment and 

general health hazards relating to power tools; refer to 
General and Electrical Safety sections in this manual

• 

 Important: It is imperative to follow all national safety 

regulations concerning installation, operation and 
maintenance

• 

 Do not allow anyone under the age of 18 years to use this 

tool, and ensure that operators are qualiied and familiar 

with the operating and safety instructions

•  When using the drill, use safety equipment including safety 

glasses or shield, ear defenders, and protective clothing 
including safety gloves. Wear a dust mask if the drilling 
operation creates dust

• 

 Use metal and voltage detectors to locate concealed 

electric, water or gas lines. Avoid touching live components 
or conductors

• 

 Extension cable reels used with this tool must be 

completely unwound. Minimum conductor cross section: 
1.0mm2

• 

 When using this tool outdoors, connect to a power supply 

with an RCD device and minimum 1.5mm2 extension cable 
with water protected plugs in good working order

•  Ensure that the chisel or drill bit is securely ixed in the 

chuck. Insecure drill bits can be ejected from the machine 
causing a hazard

•  Ensure that the lighting is adequate

• 

 Ensure that the drill bit is in contact with the workpiece prior 

to starting up the tool

•  Before drilling, check that there is suficient clearance for 

the drill bit under the workpiece

• 

 Use both hands when operating this tool

• 

 Use auxiliary handles supplied with the tool

• 

 Do not put pressure on the tool, to do so would shorten its 

service life

• 

 Drill bits get hot during operation, allow to cool prior to 

handling them

• 

 Never use your hands to remove sawdust, chips or waste 

close by the bit

• 

 If you are interrupted when operating the drill, complete the 

process and switch off before looking up

• 

 Where possible, use clamps or a vice to hold your work

• 

 Always disconnect the hammer drill from the electric supply 

before changing a chisel or drill bit

• 

 Examine the chuck regularly for signs of wear or damage. 

Have damaged parts repaired by a qualiied service centre

• 

 Always wait until the drill has come to a complete stop 

before putting it down

• 

 On completion of the work, disconnect the tool from the 

power source and remove chisel/bit from the machine

•  Periodically check all nuts, bolts and other ixings and 

tighten where necessary

PDF Compressor Pro