VOX Operation is not recommended if you plan to use your device in a noisy or
windy environment.
Note: VOX mode will be over ride when you press the PTT button.
8, Scanning for an active radio channel
Press and hold the UP
▲
button 2 seconds: The “SCAN” function indicator will
appear on the display and the channel will scan continuously from 1 to 22. Once
an active channel is found, the scanning will stop and you can listen to the
transmission.
When the transmission is on the found channel stop, the scanning will resume
automatically.
Note: If you press PTT button while listening to a found channel, the device will
go back to stand-by mode on the found channel.
9, Monitor
Press and hold the DOWN
▼
button about 3 seconds to active monitor.
Release the DOWN
▼
button return to stand by mode.
10, Setting the Call tones
The device has 10 call tones.
Press the MENU button 4 times, “CA” is displayed and on the current call tone.
Press the UP
▲
/Down
▼
button to change another call tones.
Press the PTT button to confirm and return to stand-by mode.
11, Sending a call tone
Press the PTT button one time quickly, the call tone will be transmitted on the
setting channel.
12, Roger Beep On/Off
After the PTT button us released, the device will send out a roger beep to
confirm that have stopped talking.
Press the MENU button 5 times, “RO” will be displayed.
Press the UP
▲
/Down
▼
button disable the roger beep ON/OFF.
Press The PTT button to confirm your selection and return to the stand-by mode.
13, Backlit display
Press any button except for the MENU button to activate the back light of the
LCD display. The back light will light on about 5 seconds.
14, Earpiece connection
The device can be used with earpiece (If there is earpiece packed together with
the device).
The connector is located on the top of the device.
Insert the earpiece plug into the connector (2.5mm jack).
