29
The following settings are saved:
•
Function generator: frequency, level, waveform, output On/Off, TTL On/Off
•
Pulse generator: frequency, level, duty cycle, CMOS On/Off, TTL On/Off
•
Frequency counter: input signal type
•
DC power supplies: positive voltage, negative voltage
•
Logic switches: state, TTL/CMOS
•
SPDT switches state
•
Logic indicator: TTL/CMOS
•
Logic probe: TTL/CMOS, PLS/MEM
7.2.2 State name
You can assign a custom name to each of the ten storage locations. The name
can contain up to 15 characters. You can assign the same custom name to
different storage locations.
To assign a name to the selected location select the
Enter name
option. The
following screen will appear:
Figure 16
Use the arrow soft keys to select a character in the name box (“1: No name”).
Press the “Set” soft key to insert a character in the name box. Use the arrow
keys to move the selection.
Use the “CAPS”
option to switch between upper-case and lower-case.
Use the “ “ option to delete a character in the name box.
To enter the desired character, press the “OK” soft key.
When the state name is specified, move the cursor to the number of the state (1
in this case) and press “Back” to go back to the Store state menu.
The name entered for the selected state will be saved only when you save the
state in memory by selecting the
Store state
option.
