Global Water
800-876-1172
•
globalw.com
5.
Protecting your Programming Parameters
a)
Pull off the ring. Keep it as a personal key.
b)
Use ring in reverse position on the sensor (PROG. LOCK
position.)
Figure 7
Figure 8
Figure 9
Unlocked Position
Locked Position
6.
Factory Settings
a)
Enter code “989” to return to factory settings.
Note: During the programming process, if there is no new action taken within
30 seconds, the sensor will return to “measurement display” without saving
your changes. You will have to go through the entire program a second time to
re-program the unit.
- 12 -
