244280
www.globalindustrial.com
9
Press
1
key to set to 2%, display shows “
SPL.002
”
Press
2
key to
set to 5%, display shows “
SPL.005
”
Press
3
key to set to 10%, display shows “
SPL.010
”
Press
4
key to set to 20%, display shows “
SPL.020
”
Press
5
key to set to 50%, display shows “
SPL.050
”
Press
6
key to set to 100%, display shows “
SPL.100
”
Press
Tare
key to confirm. Remove the sample, and put another weight on the scale, it will
display the percentage of the original sample.
For example, if 6kg is placed on the scale and the
%
key is pressed the display will show
100.00%. Press
Tare
key.
Removing the 6kg weight and putting a 3kg weight on the scale the display will show 50% as
3kg is 50% of 6kg.
Press the
FUNC
key will return the scale to normal weighing mode.
Note: if sampling weight is set to 1%, the weight must be more than 50d, if set to 2%, the
weight must be more than 100d. The rest % need to be set in the same manner.
4.9 Manual Accumulation
Accumulation can be used in both weighing and counting modes.
When the scale is set to manual accumulation the weight displayed will be stored in memory
when the
ACCU
key is pressed and the weight is stable.
The display will show "
ACC001
" and then the total in memory for 2 seconds before returning
to normal.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press
ACCU
, the display will show "ACC 002" and then show the new total.
Continue until all weights have been added.
To view the totals in memory, press the
ACCU
key when the scale is at zero. The display will
show the total number of items "ACC xxx" then the total weight before returning to zero.
Note:
In all cases the scale must return to zero or a negative number before another sample
can be added to the memory. More product can then be added and
ACCU
pressed again.
This can continue for up to 99 entries, or until the capacity weight display is exceeded.
