SECTION 4
MAINTENANCE
Servicing Notes
Servicing should be carried out annually by a competent person such as a GAS
SAFE registered engineer. The service should include visually checking the
chimney and fire opening for accumulations of debris and a smoke test to check
for a positive up-draught in the chimney.
The condition of the coals / pebbles should be checked and
if necessary the
whole set should be replaced with a genuine replacement set.
The burner assembly is designed to be removed as a complete unit for ease of
access.
After any servicing work a gas tightness check must always be
carried out.
For Diagrams refer to Section 2
4.1
Removing the burner assembly from the fire.
4.1.1
Prepare work area (lay down dust sheets etc.)
4.1.2
Lift the fender and ash pan cover or Contemporary trim out of the way
and put them in a safe location. Remove the loose coals / pebbles from
the fuel bed and front ceramic rail. Remove the front ceramic from the
rail. Unscrew the two pozi-driv fixing screws which secure the burner
heat shield and remove it from the fire.
4.1.3
Isolate the gas supply and remove the inlet pipe from the appliance
inlet elbow. Unscrew and remove the four screws which retain the
burner. Remove the HT lead from the Pilot electrode and remove the
burner assembly from the fire, ensuring not to pull to tightly on the PCB
wiring. Cut the cable tie from the remote infrared eye self adhesive
pad, which will be situated on the hearth panel, flush with the front edge
of the ashpan cover.
4.1.4
To refit the burner assembly. Ensure wiring is fitted correctly to the PCB
assembly. Refit the HT ignition lead. Push the base of the control panel
fully into the fire and secure with the four screws. Refit the gas supply
pipe and carry out a gas tightness test. Refit the burner heat shield
then refit the coals / pebbles referring to section 3 for the correct coal /
pebble layout. The infrared eye must be cable tied back to the self
adhesive pad which will be situated on the hearth panel. The fender
and ash pan cover or Contemporary trim & ashpan can now be
re-positioned.
29
