INSTRUCTION MANUAL
Issue.
08 / 2004
Pag.
34 - 42
WARNING
DANGER
8.4. IMPORTANT SAFETY REGULATIONS, TO OBSERVE DURING EQUIPMENT
OPERATION BOTH WITH VEHICLE ON THE LIFT OR WITHOUT.
Avoid to leave objects or rags or anything else on the ramps: their accidental fall
may cause damage during the lifting operations.
Keep the ramps clean, avoid the deposit of oily substances that may cause the
sliding of the load.
It is absolutely forbidden to use the ramps as a working place.
It is absolutely forbidden to stay on the ramps both when the bench is stopped and
when is moving.
During lifting and lowering check the vehicle “at sight” and make sure that it is
perfectly stable on the side ramps.
LIST OF MAJOR WARNINGS FOR SAFETY. THE SAME INFORMATION IS ALSO REPORTED
ON A PLATE ATTACHED ON THE POWER UNIT CONSOLE.
-
For the use of trained operators only.
-
It is forbidden to use this lift for any other purpose different from those provided in
this instruction manual.
-
Do not allow anyone on or inside the loaded vehicle or on the structure of the lift.
-
It is forbidden to overload the lift exceeding its maximum capacity.
-
Be sure that the weight of the vehicle to be lifted and its distribution are in
conformity with the instruction manual.
-
Always check that no dangerous conditions may cause injury or property damage
during lifting operations.
-
Always check that no object may obstruct the descent of the lift.
-
The presence of any person within the working area of the lift is strictly forbidden.
-
In case of breakdown press the emergency button on the remote control.
-
Before making any intervention the main switch must be positioned on
O
.
-
Service and repair are to be carried out by qualified personnel only.
-
The manumission of safety devices imply the infringement of the European Body of
Legislation on Safety.
Summary of Contents for Super Rotax
