INSTRUCTION MANUAL
Issue.
08 / 2004
Pag.
38 - 42
DANGER
WARNING
12.
MAINTENANCE
Ordinary maintenance operations are easy and consist of general cleaning of the lifting bench at
the end of a work shift and after the repair of a vehicle.
Checks and operations
Keep the following parts clean from dust, oil deposits, soil or any other dirty material that can
drop from the vehicle under repair.
–
The limit switch of the up-stroke.
–
The ramps and side runners.
–
The crossbeams and their sliding plates.
–
The toothed guide of the pulling arms.
Once a year you should
grease
the guides for the connecting
rods bearings, both lower and upper ones, and the pulling
tower guide track underneath the bench.
Picture 12-01
Î
In order to reach the upper guides you should remove the
perforated plate.
Picture 12-02
Î
Before proceeding with this operation you should lower the
L.B. and disconnect the main switch.
After maintenance operations the
protection plate must be repositioned.
For ordinary cleaning do not use water, petrol or other flammable liquids. Use
cloths or paper and eventually also dry compressed air jets.
–
Make periodic inspections to the dowels at the base of the bench.
–
As for the hydraulic plant, its maintenance consists of a periodic visual inspection of the plant
for any oil leakage. Check and tighten the joints, especially those which connect flexible pipes
to rigid ones . If everything is dry and without oil traces, it means that the plant is well sealed.
–
The electric plant does not require any maintenance.
Summary of Contents for Super Rotax
