31
EN
POWER SUPPLY CONNECTION
The supply voltage must correspond to the voltage indicated on the identification plate placed
inside the hood. If the hood is equipped with a plug, insert it in an accessible socket compliant
with the applicable regulations. If the hood is not equipped with a plug, the installation should be
carried out by a certified specialist (e.g. an electrician).
CLEANING AND MAINTENANCE
Before performing any maintenance operations, unplug the device from the socket. Use mild de-
tergents for cleaning. Do not use abrasive cleaning products. The hood should be cleaned at least
once a month or every 35 hours of operation. DO NOT USE ALCOHOL-BASED CLEANING AGENTS.
Inox parts should be cleaned with special product (e.g. BERNER).
CARBON FILTER
The hood may be equipped with a carbon filter. Use the filter only when the hood is not connected
to the ventilation duct. Place the filter on the turbine housing as shown in
Fig. 13
. The filter should
be replaced every 3-6 months.
CAUTION!
DO NOT WASH OR REUSE THE CARBON
FILTER.
CONNECTION DIAGRAM FOR HOOD IN
RECIRCULATION MODE
FILTER ASSEMBLY
FILTER DISASSEMBLY
Fig. 13
Fig. 14
VENTILATION GRILLE
AIR IS REDIRECTED TO
THE ROOM
ROUND / FLAT DUCT
Summary of Contents for Alario 60
Page 12: ...12 PL 6 Zamontuj filtr przeciwt uszczowy 7 Pod cz rur do kr ca silnika Rys 11 Rys 12...
Page 30: ...30 EN 6 Install the grease filter 7 Connect the duct to the motor connection Fig 11 Fig 12...
Page 48: ...48 DE 6 Den Fettfilter einsetzen 7 Verbinden Sie das Rohr mit dem Motorstutzen Abb 11 Abb 12...
