36
EN
Problem
Possible reason
Solution
Number „4” on the display is blinking, and
after 5 min. the speed level changes to 3*.
The hood is equipped with a turbo mode,
which automatically changes to level 3 af-
ter 5 minutes of operation to save energy.
The turbo mode should only be used for
intensive cooking.
The hood can only be operated using
the control panel, it does not react to the
remote control*.
The battery in the remote control is flat or
the remote is too far from the device.
Replace the battery.
Low suction efficiency.
The filters may be dirty.
Wash or replace the anti-grease filter.
Replace the carbon filter (if any).
One or more light bulbs are not lit.
Burnt halogen or LED bulb.
Replace the bulb in accordance with the
user manual.
The hood generates excessive noise and
vibration.
The reason may be incorrect installa-
tion of the hood to the wall or kitchen
cabinet. Not all of the screws required
were screwed in, or the screws were not
tightened enough, leaving clearance.
The hood must be fixed to the wall or cab-
inet using the number of screws indicated
by the manufacturer. After adjusting the
position of the hood vertically and hori-
zontally, tighten all the mounting screws.
* applies to range hoods with touch control
If after following the above-mentioned guidelines the problem is still not solved, contact an authorised household appliance repair service.
Do not try to repair the hood yourself. A list of authorised repair centers is provided on the warranty card and on the website.
WARRANTY
Within the period of 2 years from the date of purchase of the product, GLOBALO undertakes to cov-
er all repair costs for faults which are obviously caused by manufacturing defects. The warranty
does not cover burnt bulbs, fuses and filters, as well as any damage due to faulty installation and
ventilation system.
In addition, the warranty does not apply in the following cases:
• Application in the catering industry.
• Application for any other purposes than household use.
• Use of the device not in accordance with the operating instructions and its intended purpose.
• Circumstances beyond the control of the manufacturer, including, without limitation: uncon-
trolled power surge, flooding, obstruction of the ventilation duct.
• Apparent mechanical damage after installation of the device.
LED STRIP REPLACEMENT
The installation must be carried out by qualified personnel.
Summary of Contents for Alario 60
Page 12: ...12 PL 6 Zamontuj filtr przeciwt uszczowy 7 Pod cz rur do kr ca silnika Rys 11 Rys 12...
Page 30: ...30 EN 6 Install the grease filter 7 Connect the duct to the motor connection Fig 11 Fig 12...
Page 48: ...48 DE 6 Den Fettfilter einsetzen 7 Verbinden Sie das Rohr mit dem Motorstutzen Abb 11 Abb 12...
