206M 201805
24
please do not use the equipment and contact with the supplier. Standard accessories with
equipment are shown as follow:
Screw stud of drive axis 1
Balancing pliers 1
Allen wrench 1
Measure caliper 1
Quick release nut 1
Cone 3
Counterweight (100g) 1
4.2 Installing machine
4.2.1The balancer must be installed on firm platform which is more than 60CM high and
fixed with 3pcs M8 screws
4.2.2 There should be 500mm around the balancer in order to operate conveniently
33
4m
m
923mm
378mm
Overall size Installation holes position (bottom view)
4.3 Installing screw rod
Install screw rod on the main axis with M10 × 150 socket bolt, then fasten the bolt. (Refer
to Fig 4-1)
Fig 4-1
5. LED display control panel and function keys
5.1 Introduction of display control panel
Fig 5-1is figure of keyboard and display
，
introduction is as follows:
